Instructions for installing the MZP (Inconspicuous Obstacle)
1. Put the MZP Tangled Wire in the right place. where it will be installed. Important note: after deployment, the MZP is no longer collected in the original bay. Those. you need to take into account that it will no longer be possible to install, and then assemble it back and transfer it to another place.
2 and 3 . Divide the bay into two parts and spread out in two directions. You don't need to cut anything.
4 and 5. Stretch two rows of the bay to its full length.
6 and 7. Lay each row outward. Two rows will make four.
8. Fix the lower pair of turns with pegs. You need to fix with pegs a series of spirals with the thickest wire.
9. Holding the coils, as shown in the figure, you need to slowly move the MZP.
10. With such movement and stretching, spirals of thick wire will appear below. Spirals of thin wire will come up.
After that, fix the extreme row of thick wire spirals with pegs.
11. The outer rows are fixed with pegs. To increase the height of the MZP, you can use supports to which to attach coils of thin wire . Installation of MZP "Putanka" is completed.
